MATLAB XPC TARGET 4 - IO Uživatelská příručka stáhnout pdf (Strana 16)

2 Advanced Procedures

2-6

5 From the block library, click-and-drag the name of an A/D board to the

Simulink block diagram. Likewise, click-and-drag the name of a D/A board

to your model.

Simulink adds the new I/O blocks to your model.

6 Remove the signal generator block and add the analog input block in its

place. Remove the scope block and add the analog output block in its place.

The demo model

xpcosc should look like the figure shown below.

Your next task is to define the I/O block parameters. See “Defining I/O Block

Parameters” on page 2-10.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 181 182

Žádné komentáře

MATLAB XPC TARGET 4 - IO Uživatelská příručka Strana 16