MATLAB GAUGES BLOCKSET RELEASE NOTES Uživatelská příručka stáhnout pdf (Strana 17)

Moving and Selecting Blocks

1-11

Moving and Selecting Blocks

The way you move and select blocks from the Dials & Gauges Blockset is

significantly different from how you move and select a Simulink block. Dials &

Gauges Blockset blocks consist of an “active” area containing the actual

control, and a border that surrounds that area. Dials & Gauges Blockset blocks

are active even when a simulation is not running; that is, dragging the cursor

anywhere within the control is interpreted as attempting to change the value

of the control. This figure shows the border and the active area within a Dials

& Gauges Blockset block.

The table below tells how to manipulate a Dials & Gauges Blockset block.

Task Mouse Action

Add block to model From the Simulink Library Browser, drag the

block by its icon in the right pane.

From the library window (displaying blocks as

instruments), drag the block by its border.

Move block Drag the block’s border. You can do this only if

the border is visible.

Select block Click on the block’s border. Or “rubber-band

select” the block.

Resize block Select the block, and then drag one of the

selection handles (as you would resize a

Simulink block).

Border

Active area

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 113 114

Žádné komentáře

MATLAB GAUGES BLOCKSET RELEASE NOTES Uživatelská příručka Strana 17